Stick on interior lights

    I installed the storage compartments from Quadratec on my 03 Rubi which fit across the front of the windshield on the upper round bars and it has 2 large compartments. I would like to stick some small decent stick on LED lights under the compartment for some extra lighting up front. Some that I have looked at online were either too big or fell off due to lack of a good adhesive. 1" X 2" or 3" would work. Any suggestions.

    I think I saw some on Quadratec awhiule back that have velcro straps that will go around the roll bar. I believe they were battery operated, not sure about led though.

    I've been using the clip-on lights for 5 or 6 years. Probably just my usage, but they tend to wear out (either the magnet falls off, or the LEDs go out) in 3 years, not bad for a $10 light. :)

    Jerry / Whatevah

    2020 Gladiator Mojave - 35" Kenda Klever R/Ts, LoD aluminum side steps, Zroadz bed rack, Quadratec QRC winch bumper, Superwinch EPi 9.0, Kleinn on-board air, fire truck airhorn, lots of lights, Yaesu ham radio with GPS tracker, SnailArmor tailgate panel

    Gone- 2012 JK Rubicon with stuff. Long gone- Long-arm 2001 Cherokee with stuff.

    You can also use LED strips. I put bright white on my Harley and they were BRIGHT. Just wire them with a toggle and your all set. Cheap, easy , no batteries and will not fall off.

    Quote from dovertj


    You can also use LED strips. I put bright white on my Harley and they were BRIGHT. Just wire them with a toggle and your all set. Cheap, easy , no batteries and will not fall off.



    x2 on this ^^^

    I have a picture somewheres of the green ones I installed in the Jeep. They're the best one's I've had yet. They are that 12" flexible LED strips from Autozone... they have like a silicone type feel to them. They've been submerged, extreme heat and I accidentally snagged the wire once and they're still attached as strong as ever to the underside of my dash. And awesomely bright but not enough to blind you. If I can find the pic I'll post it. I also wired them to an old KC switch I had. they have a very thin profile too so they don't protrude out at all.

    Edit: here's a pic of them at night.... it was just after I installed the LEDs into the gauges. If you look right next to the CB mic you'll see a small green light. That is the KC switch... it has a green light too so it worked out pretty well.

    [img width=1200 height=896]http://www.delawareja.com/gall…nloadItem&g2_itemId=41845[/img]

    Your life is made up of 2 dates and a dash... make the most of the dash!

    Edited once, last by Kuntryboy816 ().

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login