If I remove the yoke from a Dana 30 to replace the seal, can i simply reinstall it or do I need to replace a crush sleeve?
Pinion seal on a Dana 30
-
-
no because i doubt u would put the 6-800 lbs i to while retightening the nut to effect the sleeve. Somewhere i the neighborhood of 300ft-lbs is all u need. Also inspect the nut and replace if it gets buggered up upon removal.
-
Thank you
-
What model dana 30 because depending you may not even have a crush sleeve, think they only have them on LP TJ
-
Only hp d30 in xj/yj use shims. All others have crush sleaves.
-
It's a low pinion from a 02 TJ. Thanks for the confirmation.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!