Posts by jaytj01
-
-
I’m looking for a rear driveshaft that will fit a jk with 3.5” of lift
-
I’m looking for a 4.10 gear set for a high pinion Dana 30
-
Thanks. I am supposed to be buying one from dan111555. If it falls through I'll get in touch with you.
-
I am looking for a gauge cluster for a 2001 TJ. Thanks
-
They are not reversed, I kept the factory plugs on. I cut any wires off the factory jeep harness that were not used, but the ECT and oil sensors wires wernt touched. I have no idea what is going on with it
-
Yea all of the stock jeep sensors are swapped over
-
I have a set of dana 44 4.10 thick cut gears. They are used but in good shape....Make me an offer
I also have a set of brand new in the box G2 HP dana 30 reverse cut 4.56 gears... $100 -
-
I have 2001 TJ that i have swapped a 5.3 ls motor into. I am running the GM ECU and the factory jeep ECU in order to keep my factory gauges. I am using the module from novak for the tach.
All of the gauges are working except the engine coolant temp, and oil pressure. the coolant temp stays at 0, and when I turn the key to the "ON" position with the engine off the oil pressure reads 40.
I have checked that there is voltage at the sensor, and that both have grounds. My scanner will read engine coolant temp through the jeep ECU but it will not read oil pressure. I dont understand why the scanner will read the coolant temp but the gauges wont?
Any help would be appreciated.
-
I am selling a Spartan ngauge for a 6.7 powerstroke. price is O.B.O Here is the link to the CL ad
-
It's sold sorry.
-
I'm selling a Drolet Savannah wood stove with chimney pipe. I am asking $450 OBO. Thanks
-
I am looking for a jeep that is being parted out, I need to cut a small part of the floor board out to repair mine. If you are parting one out or know someone who is please let me know. Thanks.
-
I know the fuel pumps are different on the 03's and up. They have a return line, the 02 and older are regulated at the tank. But, I don't know if the tanks are different
-
so does the 8.8 bolt up directly or is there cutting and welding?
There is always cutting and welding -
Ok let me know, if not it is getting trashed Thursday
-
Yea. The only thing it needs is brakes
-
Bump
-
I have an all stock Dana 35 with 3.07 gears. Located in Newark.