I'll have to double check when I get home, but I don't think it does
Posts by jaytj01
-
-
The resistance of the sensor is good, and I have 5v and ground at the sensor
-
Ok, so long story short I am doing a 5.3 swap, and in order for my factory engine temp sensor to work I reused my factory sensor and installed it into the block.
The engine coolant sensor wont read. I have 5 volts at the sensor, but I have a feeling that during my demo I demoed ground that the ECU needs to reference the voltage too. does anyone know what ground this might be? thanks in advance
-
-
-
I have a nv3550 bell housing
-
How much?
-
I am looking for a Dana 30( high or low pinion) with 410 gears for a tj
Let me know if you have one. Thanks -
-
No 6 cyl sounds like this
External Content www.youtube.comContent embedded from external sources will not be displayed without your consent.Through the activation of external content, you agree that personal data may be transferred to third party platforms. We have provided more information on this in our privacy policy. -
Camaro oil pan saves 3" of ground clearance over the truck pan
-
-
Yea, advance adapters has a pretty complete install kit for $1700.00
I'm doing one now, by the time you get done you'll be almost $6k into it trust me....
It's all the Miscellaneous stuff that adds up. Ac relocation bracket, compressor, custom AC lines,fuel lines, fuel pump, wiring harness, Ecu programming, exhaust, custom Trans mount, misc stuff that the motor you will get will need. It's bad ass when it's done but don't believe the posts of "I did it for $3k"
If you want to look at mine or need advice I'd be glad to help -
So... you'd make a fraudulent warranty claim after posting about it on a public forum?
That is pretty F***ed up -
Pm sent
-
Where are you located?
-
my dad just bought a jeep and i am looking for a few things.
-adjustable track bars
-dana 30 4.10 gears
-dana 35 4.10 gearslet me know if you have any of these items,and how much you want for them. Thanks
-
I am looking for a skid plate for a tj gas tank. Let me know if you have one. Thanks
-
transmission or transfer case...?
I have a transfer case skid plate, im pretty positive they were all the same in regards to engine and transmission. located in newark
Yea the skid that holds the trans, there's only one. Did your come off of a auto or manual? They are different -
Like the title says, I'm looking for a stock transmission skid plate for a 2001 4.0 manual. Thanks