I have an 8.8 with a Detroit locker. With the trans in neutral I can rotate the driveshaft almost 30 degrees before the rear "engages" or another way to phrase it is that I can rotate the driveshaft an 1/8th to 1/4 turn before the tires move. Is this much slop normal?
Posts by jrostocki
-
-
Aaron your are correct, the stock bearing is not the same. I have a spare case with a SYE and I took that one apart before I started to disassemble the one in the jeep. I ordered a stock bearing thinking it would fit bur the stock bearing is much smaller. I ordered another bearing that is advertised as a SYE bearing and I hope it will be the correct size. I am also assuming that most of the kits use a similar bearing.
-
Maybe I should have asked what color to paint my output shaft - it seems like the previous posts regarding painting wheels garnered much more attention
-
Si apparently no one has ever had an output bearing fail or no one cares enough to respond. Go those of you that May have an interest in this topic, I disassembled the tail housing and determined that the output nearing has failed. I ordered a stock replacement bearing and I am hoping that it will fix the issue.
-
I have a SYE of unknown origin and there seems to be an excessive amount of play in the tail shaft/output shaft. What would be the cause of this and what do I need to replace? Lastly, if it is some output shaft bearing where would I get that?
-
Hello - anyone there I sent you a PM - are you not interested anymore?
-
call me to set this up
302 250 5541 -
Came out of a 6 cyl
When do you want to pick it up -
Came off a 88 yj. Tube is fine. Located in wilm de
-
Free Dana 30 - Ratio unknown and one axle broken
jrostocki@msn.com
302-250-5541 -
What Color?
-
I have a novak adapter kit for the 5.3 to AX-15 for sale if you are interested
jamie
302-250-5541
jrostocki@msn.com -
I want both - how much and where are you located ?
-
-
-
-
-
-
Free dana 35 with two rough country 4" springs.
Came out of a yj - worked fine when pulled . Gears not known. Must also take scrap rear frame section.
jrostocki@msn.com
302 250 5541 -
$275? Any one....