Posts by 85cj7

For the jeep that you have and what you do whit it I would just get your trans rebuilt or get a used one for it .

When did you put your center console back in ?

I was going to tell you to try a new t stat but you put it on your post .

I use my buddies when I do ac work .

I fab. up some new motor Mount's and put a new exhaust on it .

You are welcome . I hope this motor works out for you .

Parts are ordered . Delete post .

It is for a ford 9" . Do you stock the parts for them ?

Thanks

Any one know wear I can get parts for my locker ? Need new seals for it .

bump

Hey Pete sorry that I have not called you . If you need me to help out I will . If I were you I would find another motor for your jeep . It would only take a day or so to do the swap . And we can do it hear at the house .
http://allentown.craigslist.org/pts/1590882326.html

http://baltimore.craigslist.org/pts/1581918165.html

http://harrisburg.craigslist.org/pts/1601333425.html

I have a trans jack but I am kinda far away from you .

Jack one side of the jeep up just enough to get a pry bar under the tire , then take your pry bar and lift up on the tire whit one hand and hold the ball joint in the other if the ball joint moves up and down it is bad .

If want it fixed you can stop buy the house tomarrow night I will do it for you . Should only take about an hour to do . Just shoot me a pm and I will give you my address .

It will bolt up . I have a yj tub on my cj .

I think that you will need to swap out the heads to go to a efi set up on your 351 . I think that the bolt pattern is different on the carbed heads & intake then the efi ones .

I have a bell that will work for your swap . free come and get it . I put a t18 in mine 2 years ago , but i went to a hydraulic set up for the clutch nice on the trail and in traffic . I used the Novak adapter and rebuild kit for mine it work's well .

I like the 5.0 swap but I have always been a ford guy .