I plan on regearing that's not the problem currently. My issue is that I can find 8.8 rears but I don't know anyone who can weld the brackets on. Also what other parts are needed like adjustable control arms and how it's going to set. Some say it'll sit higher. If someone who has had this done or can do it would give me some information as to what I would need and expect
Posts by Mr93wrangler
-
-
Im Currently running a 98 4.0 5 spd tj with stock d35 3.07 gears. The previous owner "rebuilt" the rear but I noticed last night that the pinion is about to fall out. My question is what is needed to install a 8.8 Ford rear? It's going to have a 3" spring lift and no bigger than 35's on it but obviously it's not all getting done at once. Could the rear be done then the lift? I don't have welding or fabrication skills to set up the rear. It's not my daily driver but I'm not rich either! If anyone could help me with any information or even point me in a good direction I would greatly appreciate it!
-
Thanks sure does mean alot. I work in Pocomoke Maryland so I wouldn't even mind the drive to Salisbury! I'm interested in being involved in a jeep club just can't see driving real far and I understand being in the middle of nowhere! Lol
-
I sure wish there were social jeep meets not so far away from where I am. Here I am a new tj owner looking to meet some jeep owners who I can call new friends. Last meet I went to everyone around was like who's this guy? Maybe cause I'm not riding around in a decked out jk or something I'm not visible! Lol
-
How complex is it and how much do the kits run?
-
-
I need some help with my ax15! I have a 98 tj that has 180k on it. I bought it about 5k ago. I'm having a issue shifting into 3rd gear and a little on 4th. I recently changed the fluid to red line mtl. That seemed to help a bit. I replaced the master and slave cylinders together as they were pre bled. According to the po the clutch is original. Could it be the synchronizers are going up?
-
Would you mind sending me a Closer picture? Are they with or without bars?
-
Currently looking for a fuel tank skid plate for my 98 tj. Thanks
-
I'm interested in looking at getting a set also but not sure on the brand. I want something that will go to the bottom of the door opening. Looking on the a-z website some appear to go higher than others. Anyone have any on their tj? I'd like to see some pictures and hear input!
-
Just broke down and ordered 4 qts of red line mt90. Free shipping from jegs. I hopefully will get it tues!
-
What's the best recommend fluid to put in my 98 tj with the ax15 trans? I've been told red line but am not sure if I should use mt90 or mtl. Also how much should I use? Thanks
-
What spring lifts are idea without breaking the bank? I won't be offroading much but if I do it'll not be harsh.
-
Thanks
-
-
I'm wondering what everyone's recommendations are for clutch master and slave cylinders are. I'm looking to replace mine as a prebled unit possibly before the clutch goes in. It's a 98 tj 4.0 ax15 trans. Thanks
-
I sent u a email sg1998! You never responded
-
I've got one
-
Thanks I'll check it out!
-
Who sells them together?