I need help I have just did the 4.0 and ax-15 swap in to my yj and now I can't get the clutch it disengage all the way.. .. I have a totaly new set up, ( flywheel, clutch, slave, master) the trans is out of a 89 xj and the engine is out of a 93 xj... any and all help please!! thanks Mike
clutch help!!
-
-
did you bleed the hydraulic system through the slave cylinder?...sometimes it can be a pain getting all the air out.
-
yeah appently after posting this I went back out and the clutch master cly kicked... it was brand new too... now I have fluid all on the floor that I have been tring to get up... I hope this is the full problem..
-
dont forget to bench bleed the master cyl
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!