so today while i was supposed to be working, i decided i was going to try to make the shifter cover floor over again. I started with a piece of scrap .038" galvanized sheet steel. I decided i was going to make this one a 2 piece cover.
i made the main piece simular to the stock cover, except with a notch on the right side. i then made a smaller piece, cut a notch for the twin sticks, then i scribed the existing floor.
A little hammertite to keep it from rusting and i have a much better looking cover.
i also trimmed some of the floor where i pulled it back for the front driveshaft on the March run.
The main cover:
The twin stick cover:
All together:
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!