i also wanted to say a big thanks to aaron and don (astape and jump150) for putting in many hours of hard work to get it all finished up.
Those guys do pretty good work! ;D
i also wanted to say a big thanks to aaron and don (astape and jump150) for putting in many hours of hard work to get it all finished up.
Those guys do pretty good work! ;D
What's a "DH"?
You must be a National League guy huh John:)
.
.
.
.
.
.
.
.
.
.
I think that's "darling husband" in mommy board lingo.
so wait you guys pass emisions w/o cats? is this like common or a fluke?
Hey there's a cat there. I guess the ol' 4 banger is just a clean running motor.
Please don't gut your cat. There is a reason it's there. Gutting the cat is bad for the environment!
Sorry Chief. Mine's been hollow for 6 years and passes emissions with flying colors.
Holy LEDS batman!! When did you do all that?.............I LIKE it.........I like it allllotttt:)
1) I forgot to put a third tail light back on after I removed my tire carrier.
2) With the LED light conversion I need some red reflectors on the rear and sides.
3) Tires are sticking out too wide.
Great............sounds like another yj I know November will be here too soon
I think I will be there with Jenn and the kids(8,6,3) bringing homemade mac & cheese and softball equipment!
come on Jeep guys
A Yj that is tapping this is normally a cracked exhaust header. the 4 banger is loud
but The cracked header sounds just like a lifter tapping.
Worth looking into before a tear down.
I'd bet on that.....or a busted manifold stud.
Ebay?
I don't think Heim joints are legal for street use, are they?
Jeez, I hope so. I've been running them for 4 years now.
Did you wire all the lights onto one switch? Did you wire them in pairs?
2 per switch.
Check this out:http://www.jeeptech.com/trans/
Got mine from an old Mercedes.
Not exactly sure on the size. What are you installing? Tow hooks? If so you don't any nuts, the bolts just screw down into the frame.
Hey the torx bolts on stock yj front bumper. the bolt holes behind them on the frame should be the same thread...right.
Yep, they're the same. You might have better luck using some new "non" torx bolts; that way you can get a socket on them and crank them down. A little anti-seize wouldn't hurt either.
Your serpentine belt could be slipping.
Looks like you need (2) number 10's and my bars and you'll be uptown. ;D
Wow, where does the time go?
Yup 4 cyl. Also Chuck I will get the spreaders from your work sometime soon!
They're in my stockroom. No hurry. I don't need to be there when you come either.
Chuck