Posts by jwalk

    Did they have the MTR's in Stock? Last time I tried to order from them in January they Didn't have the 35's, website said yes, but I got an email saying no they were back ordered. I was getting Tires and wheels mounted. They still wanted to send me the wheels... go figure.

    after 5 or 6 years with the same setup they finally got me for my tires sticking out going through inspection. Does anyone have a set of 5 on 4.5 wheels/tires I can swap out tomorrow to get me through inspection on Thursday? I have 37x12.5 on 10 inch wheels so anything smaller on 8" should work.

    Bad night for me or id be there. Stay away from mug #123. Have Fun! (I'm not that dumb to post my mug #)

    I have the Tekonsha P3. A little overkill for the amount I use it. Very happy with it. It has a quick disconnect for taking it in and out.

    OMG! I can't believe there was a line to shop there. You'd think they were giving a free toaster away! anyway, like me some Cabelas, but no thanks on standing in line just to get in. That is just nuts!

    I have flush LEDs on the back as well and used to have a LED side markers in the rear. when I put my corners on I didn't cut a hole for the side markers. Last couple of years I've gotten away with using DOT approved red reflectors for side markers when I run through. They haven't said a word about it yet. think they were about 2"x3" rectangular.


    I remember when this happened. Its what I think about every time my 13 year old says she's getting my Jeep for her first car.


    I have 235 75r15 tires no lift right now. I air down to 15 psi and use 4 low. Auto. Think of others! I see plenty of trucks and folks with larger trucks and rigs that don't air down and are fine. But they dig deeper rutts which makes it worse and more likely for other folks to get stuck.



    I think of others when I can drive right off and don't have to get out and air up. And I don't spin my tires so not sure how my ruts are deeper especially since I'm following everyone tracks that went before me.

    4 Hi in 1st with 3 speed auto. Last weekend did 4 low in Drive due to linkage issues. I like to crawl over the sand.



    37's w4.10's 3 spd auto.

    Jerry may have had 8 oz but the problem was it was three weights tied together. Those tend to just tumble along the bottom. I held pretty good with a 5 oz weight.


    Eventually it will come to the right about 1.5 inches. I already put to nutserts into the tub but I didnt have the right bolts so I just popped it in with some sheet metal screws. Who am I kidding, it will probably stay like that until and if I ever catch hell from it...

    Weather permitting maybe next weekend is a good weekend to test it. Or if its raining we sit in an empty garage and get hammered drunk for no reason. :beer:



    I used rivets. Been like that for years still holding strong and has a clean look.