Posts by gavan
-
-
I had a good time. I got to drive a tractor trailer, wheel the crap,out of my jeep, almost roll it a couple times, and eat food, drink beer and burn stuff. Can it get better?
-
Just to clear this matter up, I started the ori craze
-
1.astape, there with the pete
2. jkgray10 - camping
3. 2000sahara- camping
4. Gavan - also there with the Pete.
5.Thinking this might be the introduction of fire jenga. Bring welding gloves and plenty of beer.
-
1. altierior - tentative
2. JKGray10
3. Stafford
4. Slowpoke (33s)
5. WILLYN- as long as my jeep is still running. (35s)
6. Spedly
7. JMack (33s)
8. Daddanelena
9. Tonka
10. Shorebird
11. Gavan -
4.88s, sticky 37s, 4.0, manual trans...
6. On a good day.
Miata...
11. On a good day.
Every gallon is soooo worth it though!
-
Looks like Aaron's sheet metal work has improved a bit
-
-
You can come out to Raleigh to get your axle welded if it's any closer
-
-
Installed a fuel cell. I'm going to need gaven to touch up his art work on my diff cover now that it can be seen.Damn right you do. Quality original artwork needs to stay quality and original.
-
-
The way Aaron shifts put someone behind it to pick up the fallen out toys
-
They don't pressure test cj tanks. If they try tell them to pound sand. Nicely.
-
I know of a 5.9 limited with a bad trans but a good engine.... Rest of the truck is in pretty good shape might be more than you want to spend.
-
-
Problem is front impact standards and pedestrian safety standards. An inline six is long and tall, nose needs to be longer and taller to fit it. It contributed to the killing of the 4.0 in the Jeeps and BMW puts half the engine under the dash to compensate for it.
Inline sixes are a damn good motor, though. The 4.0 in my Jeep has seen untold horrors and it's still going.
-
-
It's always the crank position sensor
-
That was more of a paving operation than off road driving.....