Can anyone in the dover or smyrna/clayton area help me out with a little welding of the floor? Like tonight or late afternoon tommorrow. Reason is I made an appointment for thursday to get the inside line-x but I just remembered I cut my floor in two spots maybe 6" in length each. Right around the console area. If anyone can help let me know. Thanks
359-9068
Welding sheet metal
-
-
try Boyds Welding, in rising sun... if you can drive it there, they should be able to weld it. They told me that the could weld anything I brought them, but that they just wouldn't fab anything. and they seem like a jeep friendly place.
-
boyds told me the same thing. if you could roll it in with everything in place then they could weld it up. anything that required prepping after you were in their garage was a no. doc holiday is out on route 8 (mile or so past bylers on south side) as well if you want to check with them...their prices had gone up the last time i was there but they guys can put down some very good welds on whatever i've needed.
-
Thanks guys. I took it to Boyd's yesterday and they were able to fit me in.
-
sorry man i didnt see this post till today. could have shot over to our place and done it. sorry man
-
Its cool. I almost contacted you guys but didnt want to impose. I how busy people can be and it was kind of last min. I will keep you in mind next though if you dont mind.
-
anytime man
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!