Delaware Jeep Association

Don't miss the last club meeting of 2026! We'll be at the Grotto Pizza in Middletown, 309 Auto Park Dr on Saturday, Nov 7th at 6pm.

We have a few of the 25th anniversary stickers (design shown in the graphic) for those that missed the last 2 events.

See…

Turned out to be a leak in the hydraulics. The Master and Slave cylinder ordered as one piece. Replaced and now runs fine. Vinny at Reno’s Transmission did the work. I trust him completely.

Turned out to be a leak in the hydraulics. The Master and Slave cylinder ordered as one piece. Replaced and now runs fine. Vinny at Reno’s Transmission did the work. I trust him completely.

Turned out to be a leak in the hydraulics. The Master and Slave cylinder ordered as one piece. Replaced and now runs fine. Vinny at Reno’s Transmission did the work. I trust him completely.

no a tj front axle always spins. If the t-case is put in 4wd it should engauge the front axle. The light is actuvated the same as a newer yj....the dentent switch grounds and the dash light turns on

Are TJ 4WD's vacuum actuated or did they move away from that?

A clutch will begin slipping before it goes. A bad clutch will also typically disengage high (as soon as you put pressure on the pedal). You'll smell it when it slips. A worn linkage will not engage until you push the pedal all the way to the floor …

sorrry dont know any shops down there but have them inspect the frame while they r under the jeep. Lots of issue on tj frames

what year? What were the symptoms? Just a dead pedal?

Received mine yesterday.