I was gonna use these on my front HP60 to mate it to my stock Jeep driveshaft. I believe its a 1310-1330 u-joint. I have 2 with zerk fittings and clips. $30 for the pair.
FS: combination u-joints
-
-
I was gonna use these on my front HP60 to mate it to my stock Jeep driveshaft. I believe its a 1310-1330 u-joint. I have 2 with zerk fittings and clips. $30 for the pair.1310 and 1330 share the same bearing cup size.
Looks more like a 1310-1350 or 1330-1350.
-
Might be a 1310/1350 combo...
-
Hmmm, well that's correct. What stock u-joint does a HP60 use? Actually I think I bought 2 so I could use it on the rear 14 bolt axle too. Bought them 3 years ago so I don't remember. I bought them from this website: http://www.dennysdriveshaft.com/c130_universal_joints.html
The 14 bolt took a 1350 and a 1410. I'm sure the smaller part is a 1310 to fit the Jeep. It says the HP60 also takes the 1350 and 1410. I'll measure them tomorrow and verify the identification.
-
Hmmm, well that's correct. What stock u-joint does a HP60 use? Actually I think I bought 2 so I could use it on the rear 14 bolt axle too. Bought them 3 years ago so I don't remember. I bought them from this website: http://www.dennysdriveshaft.com/c130_universal_joints.htmlThe 14 bolt took a 1350 and a 1410. I'm sure the smaller part is a 1310 to fit the Jeep. It says the HP60 also takes the 1350 and 1410. I'll measure them tomorrow and verify the identification.
My HP60 took a 1350 so I upgraded the DS to match it...
-
Then didn't you need a combo u-joint to connect that bigger shaft to the Jeep tcase?
-
No, it was a custom Coast ds so I wouldn't need the combo u-joints...
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!