Advice needed

    Anyone running a 400R transmission or put in a transmission and realize you need a cover for the bottom of the flywheel? because thats what I did and the only dust covers i can find will only protect against just dust...i'd like to have something a little more water proof for obvious reasons. what have been some solutions to this problem or where can i find a strong water resistant cover?

    A dust cover is normal. I don't recall ever seeing a trans with a totally sealed bell housing that was stock.

    Member since 2000

    Jeeps Owned'79 CJ5:

    Specs-

    - 258 I6

    - '93 Cherokee fuel injection and HO head,

    - bored 30 over

    - with 4x4 cam

    T18 tranny with granny low / Dana 18 t-case

    Dana 44 front and back from late '70s Wagoneer, both locked and loaded with 4.88 gears

    SOA on modified YJ springs with shackle reversa

    Fiberglass tub with 6 point cage mounted to the frame


    2015 Grand Cherokee Limited
    Spec-

    Quadratec Floor mats

    it is a sealed unit between the trans and motor , it is water tight with the main seal from them motor to the trans , the dust cover is just that so debree does not go between and wear out you seal water wil not bother it

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login