Installing an Eaton E-Locker is in my near future, but I am trying to get a handle on the wiring issues first. I plan to install the switch on a Rugged Ridge A Pillar switch mount. My question is: Where do you run the wire through the firewall on a JKU?
I looked down by the clutch and didn't see any likely candidates.
I also pulled off the side panel on the dash under the A pillar. Directly forward there is a hole with what looks like some insulation on the other side. Is this where to do it? Here's a picture:
The yellowish insulation (?) is to the left between the two bolts. There is also an interesting little plug or something on the right. Those wires lead to a bundle that can be made out inside the dash (which presumably leads through the firewall somewhere.
Anyway, any suggestions would be appreciated.