i am lost... ax-15 tranny being an a-hole to shift. anything to check off hand?? internal slave, bled fine.. brand new clutch and pressure plate, new slave and master cyl... almost acts like the clutch isn't engaging. but will sit still in gear with the clutch depressed. not grinding... just wont go in gear sometimes, and wont downshift. if i get moving, it will up shift with no problems... 2nd transmission under there, so i doubt its the tranny now.
yj clutch issue...
-
-
Just put a Small Block in it with a 4 speed and be done with it.
-
If the nut on the transmission output shaft is loose it can allow slop in the gear train (front to back) in the tranny making it harder shift into gear.
-
Just put a Small Block in it with a 4 speed and be done with it.
If the nut on the transmission output shaft is loose it can allow slop in the gear train (front to back) in the tranny making it harder shift into gear.
be tough to be a loose nut on both tranny's... but maybe this weekend i will drop the t/c AGAIN and check it. thanks slimer -
this may sound stupid but I seen it done ,put the clutch in backwards ?.
-
perhaps... anything is possible. any way to check without tearing everything back out??!!!
-
and, wouldn't it act up ALL the time? not just intermittent?
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!