I just bought acos adjustable spacers for my tj. To install, I need to drill three holes up thru the spring perch. For some reason, I just can't f***ing drill these holes. I've tried 3 sets of drill bits (2 new, one of which is cryo treated) and at this rate it's going to take 90 min per hole (1/4 pilot, 3/8 final).
I DO have the drill spinning the right way
I am keeping the drill on the slower end of the spectrum
The bit is NOT spinning in the chuck
I am checking bit tip temp and applying oil as needed
I am using moderate pressure on the drill
WHY ISNT THIS WORKING????