Here we go, just got back from deployment and its time to get all these parts in the shed on the jeep. Here were the specs as of last year.
92 Jeep YJ
2.5 and 5 speed tranny
Dana 30 and Dana 35 locked
33in goodyear MT'Rs
Mods completed before i left:
Swapped in a rebuilt 4.0 out of a 2000 Tj and harness
Rebuilt a NV-3350 and added a Centerforce stage 2 clutch
Picked up a Rubi transfer case
Added Tom woods shafts
New gauges and such
New belly skid
Mods that are left to do:
Lift SOA 1.5in Rubicon express
New wheels, Crager 8 on 6.5 steeles, with KORE bead lock kit
New tires, Pitbull rockers 37 1350 R 16's
FSJ Dana 44 and Dana 60, 4.88 with spool in the rear
New steering from ECGS, high steer and 1 ton ends
New Hydro Assist and parts
Boatsides
Tube Fenders
Led tailights
New onboard air system, with 2 tanks
I have to rewire dash and eletrical system including dual batterys
and other stuff
Anyway i started today by cutting all the brackets off the front axle and shaving down the right side spring perch about 3/4 an inch to make the axle level. My question is what is a normal pinion angle for a front axle with a SOA lift? I'm at about 15 degrees right now, ill have to post the pics later because photo bucket is being stupid.